Watching Saturation and Desaturation
Here you can watch how nitrogen moves into fictional tissues during a simulated dive and comes back out during the ascent. On the left is the nitrogen in the breathing gas, on the right the nitrogen in three tissues with different half-times. Each dot stands for 0.05 bar, 20 dots for 1 bar. All tissues are exposed to the same ambient pressure. Even so, they saturate at different speeds until they reach equilibrium with the breathing gas, and they desaturate at different speeds during the ascent. With deco stops and deco gases you can see how desaturation can be controlled.
- Time
- Phase
- Depth
- Ambient pressure
- Breathing gas
- N₂ in breathing gas
- Deco stops in total
- Since surfacing
- –
| fast | medium | slow | |
|---|---|---|---|
| Half-time | 5 min | 30 min | 180 min |
| N₂ in tissue | |||
| Saturation | |||
| M-value | |||
| Gradient factor | |||
| GF at surfacing |
Dive profile
Simplifications: three didactic tissues with rounded values based on ZH-L16C, without water vapour and without helium. Descent at 18 m/min, ascent at 9 m/min. Only one dive is planned, no repetitive dive. Deco stops in 3 m steps: the ascent to the next stop only continues when no tissue would exceed the selected gradient factor there. The gradient factor (GF) states what share of the allowed supersaturation above ambient pressure is used. This is not a deco plan for real dives. Nitrox can only be selected down to its maximum depth at pO₂ 1.4 bar. The bubbles are purely didactic: how many bubbles really form cannot be calculated. Here their amount depends on the supersaturation on reaching the surface. After surfacing they keep increasing, peak after about 30 minutes and then slowly fade, based on Doppler measurements after dives.